|
aHR0cDovL2ZyZWVzaGlwLmNvLmty
- ¸ðµ¨ ¹øÈ£: Car Dent Repair Dent Puller
- ±Ù¿ø: CN (Á¤Ç°)
- feature 1: Auto Repair Tool
- feature 2: Car Dent Repair Dent Puller Kit
- feature 3: Car Dent Removal
- feature 4: Car Body Denting
- feature 5: Car Dent Puller
- feature 6: Auto Dent Removal
- feature 7: Dent Paintless Repair
- feature 8: Auto Body Repair Tool
- feature 9: Car Body Dent Puller
¿É¼ÇÁ¤º¸[(193)Short Puller Kit][(365462)44cm Puller Kit][(496)50cm Puller Kit][(200025551)6 Pcs]
Note:This product does not contain glue gun and glue stick, if you need, need to buy another.
Packing lncluded: Short Puller Kit 1x Short T Bar 18x Short Blue Tabs (6 Sizes) 44cm Puller Kit 20x Short Blue Tabs (5 Sizes) 1x 44cm T Bar Tools 50cm Puller Kit 20x Short Blue Tabs (5 Sizes) 1x 50cm T Bar Tools 6 Pcs 4 * Long Blue Tabs (2 Sizes) 2 * Holder (2 Sizes) Description: This Paintless Dent Repair T-Bar puller is a lightweight glue tab pulling tool, meant to be used when repairing pressure dents and any dent that isn`t sharp or creased. The tension puller works well with a tap down hammer when pulling large dents. It`s very easy to control, everyone can removal the dent easily by yourself.
Description: This Paintless Dent Repair T-Bar puller is a lightweight glue tab pulling tool, meant to be used when repairing pressure dents and any dent that isn`t sharp or creased. The tension puller works well with a tap down hammer when pulling large dents. It`s very easy to control, everyone can removal the dent easily by yourself. How to use: 1.Clean the dent with a clean wet cloth; 2.Mount the glue stick into the glue gun,pull the trigger to let the glue stick enter into the glue gun, connect the power source and preheat for 5 minutes; 3.Use a proper drawing gasket. Large dent requires a large drawing gasket. (Note: The larger the drawing gasket is, the larger the drawing force is); 4. Pull the trigger and apply the drawing gasket with extruded glue (The 4 holes of gasket should be applied with hot melt glue); 5. Fast place the drawing gasket with hot melt glue at the center of dent, press lightly until the glue cures and adheres (Let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter); 6. Align the T-shaped repairer and press the drawing gasket with hot melt glue, pull the sliding rod backwards to pull up the dent; 7. Check with a Line board. If dent still exists, knock it slightly with a flattening hammer or pen; 8. Clean the repaired place with a clean wet cloth.
|
|
|
|
|