1:Take out your stock license plate light at the back of your car.
2:Fix the camera to where the stock license plate light was.
3:Connect the built-in license plate light of the camera to where the
stock license plate light was connected to get the power .
4:Connect the power of the camera to your brake lights - red wire to
positive and black wire to negative.
5:Connect the video cable of the camera to the extension cord.
6:Connect the extension cord to your car monitor.
7:You will see the images when your car is in reverse shift.
Key Features:
1 .High-definition and 170 degree wide viewing angles
2. with good waterproof function.
3. Applicable to variety of Vehicles: car, truck, RV, mini-van etc
4. Solve the issue of bad car Rear view effect, can help parking and reduce incidents and accident.
5. Support NTSC TV system
6. With its elegant and contemporary design, this camera is very popular
7. Made of high quality and durable material
8. Its simple and modest design and small size won\`t draw any attention.
Parameters:
1.Pixels: 648(H) * 488(V)
2.Power: DC 12V
3.View Angle: 170 degree
4.Image Sensor: CCD chip
5.TV system: NTSC
6.Horizontal Resolution: 600 TV lines
7.Lens: 22mm
8.Sync. System: internal
9.S/N Ratio: >48Db
10.Electronic Shutter: 1/60 to 1/100,000 seconds
11.Video Output: 1.0Vpp, 75Ohm
12.White Balance: Auto
13.Water-proof: IP68
14.Video Cable Length: about 6m(as the picture showed)
1.Ordinary Package include :
1 x CCD CHIP Car Rear View Camera
1 x 6M video cables & 1M Power Cable (connecting with the tailight power)
1 x user manual
2.With Power Relay Package include :
1 x CCD CHIP Car Rear View Camera
1 x 6M Power RelayCable (connecting with the tailight power)
1 x user manual
3.With Wireless Package include :
1 x CCD CHIP Car Rear View Camera
1x Wireless Transmitter
1x Wireless Receiver
1 x user manual