Product Details:
Parts#: 03F906262B
Warranty: 3 years
Constructed from high quality material.
Manufactured with precision to meet OE standards; Easy installation.
"Please check the Part number and item pics clearly,confirm suited to your needs."
Fit For:
For AUDI
For AUDI A1 2011-2014
For AUDI A3 / S3 / Sportback / Quattro 2009-2014
For AUDI A3 Cabriolet 2008-2014
For VOLSKWAGEN
For VOLSKWAGEN BEETLE 2011-2014
For VOLSKWAGEN CADDY 2011-2014
For VOLSKWAGEN GOLF 2009-2014
For VOLSKWAGEN GOLF PLUS 2012-2014
For VOLSKWAGEN JETTA 2011-2014
For VOLSKWAGEN POLO 2010-2014
For VOLSKWAGEN TOURAN 2011-2014
For SEAT
For SEAT ALTEA 2007-2014
For SEAT IBIZA 2009-2014
For SEAT LEON 2006-2014
For SKODA
For SKODA FABIA 2011-2014
For SKODA OCTAVIA 2009-2014
For SKODA ROOMSTER 2011-2014
For SKODA YETI 2010-2014
Q&A
Q:Why does the oxygen sensor have false alarm, after installation ? A: The clearing of the errors can be obtained on most systems when the vehicle battery is disconnected for at least 60 seconds. The assignment of the new sensor parameters is done automatically when the errors are cleared, but in some systems a short adapting tour is required. In this case the vehicle has to be driven on the road for some 10-15 minutes, in order to have the ECU adapt itself to the new sensor.
Q: How do I know the O2 sensor is good or not ? A: The only way to know if the O2 sensor is functioning normally is to check its responsiveness to changes in the air/fuel mixture, by Voltage Measurement or Waveform Simulation.
Q:How should I install oxygen sensor ? A: The following is the installation instructions: Use the correct part number as listed in the application catalogue ,Do not use sensor if i has been dropped ,Remove protection cap just prior to installation;
Firstly install sensor body ensuring lead wire is not twisted or bent , Do not use impact wrench or socket type wrench to install sensor ,M18 sensors - install finger tight then 1/2-3/4 turn with a wrench (35-45Nm) ;
Then connect and route lead wire as originally installed , Do not allow lead wire to touch exhaust manifold or any other hot component ,Do not apply any substances (especially oil or grease) to connector sensor ,Do not use leaded fuels,silicone or metal based additives.
![](https://ae01.alicdn.com/kf/H11409c7776614f6fabb0b14f3049fcb99.png)
Q:When should replace the oxygen sensor?
A:Oxygen Sensor Failure Symptoms:
Reduced fuel mileage
Failed emissions testing
A check engine light
Poor drive-ability