For BMW 1 Series F52 120i 125i 118i 2016-2021 Rear Lamp Tail Lamp Cover Rear Lamp Shell Replace The Original Lampshade
Product name: Tail Lamp Cover
Material: PC (polycarbon) brand new
Applicable: Replacement of car Tail Lamp Cover with yellowing, aging and damage.
Process: high temperature injection molding, PC hard
If you have an oven, it is the best, just remove the back cover of the lamp and the bulb, then put it in the oven and heat it to 80 degrees, and heat it for 10 minutes, the glue will soften, and the lampshade and the shell will be easier to separate ;
(2) If you don't have an oven, you have to use a heat gun. The heat gun heats the sharpest corner of the headlight until it feels a little hot while wearing gloves, stop! (Note: the temperature should not be too high to prevent damage to the headlights);
2. Grab the sharp corner with both hands while it is still hot. After the corner is slightly separated, continue to use the heat gun to heat the gap of the entire headlight;
3. After the heating is over, quickly and forcefully scrape the corner and scrape it hard~~ (be sure to wear gloves to scrape, the gloves should not lose hair, avoid excessive force);
4. Everything goes well and is relatively skilled. From heating to peeling, one minute is enough. If it does not go well, continue to use the hot air gun to heat the place that is not separated, the glue softens, and it is easy to peel off with force on the hand;
5. Clean up the glue in the glue tank of the rear case as much as possible, put on gloves, then remove the decorative frame on the lampshade and install it on a new lampshade;
6. Put the glue on the pointed cover, cut the cover with scissors (don't cut too big, just cut it into a bevel) and pour the glue into the groove (the flow of glue is too small, you can cut it bigger), make sure The glue can reach half to two-thirds of the height of the glue tank (do not disconnect the glue, and ensure the same height as possible);
7. Press the new lampshade onto the back shell, and press it and find that there is overflowing glue. You can leave it alone. After the glue is dry, everything will fall off with a blade. There is glue on the surface of the lampshade, and it will be gone by wiping it with a cloth.
Reminder: Due to the complicated installation steps, it is best to go to a professional store for installationprofessional store for installation
Note: We recommend that you should air-dry for three to five days in a ventilated environment before loading the car, and do not wash the car or get rained within a week, so as to avoid water infiltration.