Now, when ignition is turned on, the display counts forward (1 to 6) indicating that it is fully functional.
For Ducati Monster 796 (ALL Year)
(Note:This style is only suitable For Monster 796!
If you encounter any questions, please be sure to contact me first, please do not leave negative comments first, I very much hope to answer your questions, thank you)
Shows current gear number
Indicates current gear from 1 to max of 6. as well as a neutral indicator.
Detects the current gear faster than other gear indicators that use speedometer/tachometer signal.
Display can be mounted anywhere
Foreword:
Congratulations on your purchase of a SEPP gear position indicator,This product will fit all Ducati fuel injected(EFI)motorcycles which have on board Diagnostic System connector. This connector is referred as DDS(Ducati Diagnostic System) in the Ducati manuals.Unlike other gear indicators available for your bike,this product connects to the diagnostic connector.It make the installation very sample. The unit reads data directly from the ECU, offering faster and more reliable readings than competing products.The display is auto learning,there are no button and no ``programming wire`` Know limitations;Your bike is not equipped with Gear Position Sensor. therefore determining the gear in use is only possible when the engine is running and the clutch is released.
Instructions Guide:
-Find the BLACK, 4-pole diagnostic connector (also called as DDA) under the seat or under the fuel tank
-Detach the cover (cap) from the plug and connect theGear Indicatorplug.
-Route the cable to the mounting location along the frame.
-Peel the green plastic off from the back of the unit, and mount the display.
-Secure the cable with the cable ties supplied.
-The red cable connects to the +12V power supply positive.
Set up:
-You need to setup the module after installation. When ignition is turned on, the display counts backwards (6 to 1) indicating that the memory is clear.
-Raise the rear wheel off the ground by using a stand, and start the engine in Neutral. (If you do not have a stand, you may setup the unit while riding. Find a long, straight road with light traffic.)
-The display will blink ``1``.Select first gear, release the clutch, and keep the RPM above idle speed. The display is blinking faster while the unit is learning the gear.
-When the display shows ``2``, select second gear.
Repeat this process until all gears are thought (5 or 6).
The unit is programmed and should indicate the gears correctly.
Now, when ignition is turned on, the display counts forward (1 to 6) indicating that it is fully functional.