|
aHR0cDovL2ZyZWVzaGlwLmNvLmty
- ºê·£µå À̸§: TIANBANG
- ¼¾¼ À¯Çü: ¾ÐÀü
- ±Ù¿ø: CN (Á¤Ç°)
- OEM NO.: 25010.234-4355,234-4099
- À¯Çü: ³¹æ À¯Çü
- Condition: New
- Other Part Number: 234-5010.234-4355,234-4099
- Warranty: 1 Year
- Type: Oxygen Sensor
- Fitment 2: Acura MDX RL TL
- Interchange Part Number: 234-5010.234-4355,234-4368
- Fitment Type: Direct Replacement
- Fitment: Honda Accord Odyssey Pilot Ridgeline
- Manufacturer Part Number: RC3010501/060329
- Surface Finish: OE NEW
- Superseded Part Number: 2345010, 2344355, 2344368
- Country/Region of Manufacture: China
- Connector Shape: Male
- Engine: 3.0L, 3.2L, 3.5L
- UPC: Does not apply
1.Part Number: 234-5010, 234-4355, 234-4368
Package Included: 4PCS oxygen sensor,
Upstream 234-5010 x2, Downstream 234-4355 x1, 234-4368 x1
234-4355(4 wire-Oxygen Sensor): Downstream Front 1 pcs
234-4368(4 wire-Oxygen Sensor): Downstream Rear 1 pcs
234-5010(5 wire-Air Fuel Ratio Sensor): Upstream Front 1 pcs
234-5010(5 wire-Air Fuel Ratio Sensor): Upstream Rear 1 pcs
234-5010 compatible part number:
36531-RCA-A01, 36531-RCA-A02, 36531-RDJ-A01,
36531-RDM-A01, 36531-RDV-004, 24302
234-4368 compatible part number:
36531-P8D-J21, 36531-P8E-A11, 36531-P8F-A11,
36532-RDJ-A01, 36532-RCJ-A01, 36532-RCA-A51,
36542-RDJ-A01, 36542-RJA-004, 36542-RCA-A01,
36542-RCJ-A01, 36542-RKB-004
234-4355 compatible part number:
36532-PZA-L01, 36532-RCA-A51, 36532-RCJ-A01,
*Warranty: 1 Year
*Built and tested to strict quality control standards
Fit Vehicles:
For 2005-2008 Honda Pilot Ridgeline Accord 3.5L
Must Know Before Buying:
The following information is for instructional and guidance reference only. We try and make them as accurate as we can.
If Check Engine Light is on or an OBDII Trouble/Fault code occurs after installation, check the sensor with a voltmeter as below.
If the sensor is good, further diagnosis is required. There`re many different codes for specific functional failures, which are NOT necessarily relevant to the sensor. Find out what the Code means before leaving any feedbacks.
Items that have been installed, altered or contaminated are non-returnable.
1. ONLY a defective sensor after tested by a voltmeter is applied to manufacturer warranty.
2. 20% restocking fee is required if buyer bought wrong items due to not paying attention to fitment information and ask for return.
The Price, Quality & Functionality of the O2 Sensor is fully covered under our warranty & return policy. However, refund for any labor cost, expense in a dealer shop or damage due to wrong installation is NOT covered.
Q: How do I know the O2 sensor is good or not?
A: The only way to know if the O2 sensor is functioning normally is to check its responsiveness to changes in the air/fuel mixture, by Voltage Measurement or Waveform Simulation.
Use a 10-megaohm digital voltmeter. Hook up the voltmeter`s red probe to the sensor`s signal wire and the black probe to engine ground. (Use back probe method, DO NOT pierce the wire.) For a good sensor, voltage should fluctuate constantly between 0.1 and 0.9 volts after starting the engine for 2 or 3 minutes.
|
|
|
|
|